Table of Contents
Advertisement
14.5.3 Logging Operation Diagram
The timing of sampling data by the logging operation of FP7 MC Unit varies according to the
"Trigger mode" (Single / Normal / Auto) set in "CMTimeChart".
When Trigger mode is "Single"
After the logging operation is executed, the data at the point of time when the first trigger
condition is met will be logged and stored as data.
Announce trigger registration
(UM 02630_bit0)
Allow trigger use
(UM 02631_bit0)
Waveform logging enable
Waveform logging active
annunciation
Trigger detection
Logging flag
(UM 02632_bit0)
Presence/absence of
logging data
(UM 02633_bit0)
(Note): If the waveform logging enable (YB) flag turns on before turning on "Allow Trigger Use (UM02631)", the
logging operation will not be executed.
ON
OFF
ON
OFF
ON
(YB)
OFF
ON
(XB)
OFF
ON
OFF
ON
OFF
Measurement
ON
time
OFF
14.5 Start and Stop of Logging Operation
(Note)
14-17
Advertisement
Table of Contents
