Panasonic AFP7MC16EC User Manual page 395

Warning Warning
code name
Cam pattern
table over-
0111H
writing
warning
Trigger
0120H setting
warning
Tool logging
function
0121H
enable
warning
Control area
for buffer
0300H
control value
warning
Recalculation
0304H
error warning
(Note): To simplify the displays, only the lower four digits (Hex) of each warning code are displayed in the above table.
Description
The operation for the cam pattern
table rewriting request ended
abnormally as an incorrect value
was set or the execution condition
was not satisfied.
The trigger condition setting error
occurred.
When UM02613 is on (logging
enabled), it is detected that YB is
on.
The following parameters of the
control area for buffer control is
out of the range.
- Request flag control
- Request code control
- Response code control
- Axis number control
- Starting table number
- Table size
- Extended positioning table
usage setting
- Extended positioning table
usage setting corresponding axis
no.
An error occurred when
recalculation was performed.
15.4 Warning Code Table
●: Recoverable, -: Unrecoverable
Object Recovered
- Confirm the setting values of the
parameters required for rewriting
cam patterns.
- Confirm if any axes are in
synchronous operation.
If any, cancel the synchronous
All

operation and rewrite the cam
axes
pattern tables.
* The details about the cause of
the occurrence of this warning are
stored in the "cam pattern
rewriting result" area of unit
memories.
All Check that the trigger conditions

axes are set correctly.
All After setting UM02613 to off, turn

axes on the YB (logging enabled).
All
- Confirm the setting values of the
axes

parameters for control area for
/Each
buffer control.
axis
Even when the error occurred,
recalculation process in which no
Each

error occurs is executed.
axis
Check the settings and execute
the recalculation process again.
Countermeasures
15-31