Electronic Cam Setting Area - Panasonic AFP7MC16EC User Manual

Specifications

16.8.5 Electronic Cam Setting Area

Unit
Axis no. memory
no. (Hex)
UM 63F90
1
-UM 63F91
1 UM 63F92
1 UM 63F93
UM 63F94
1
-UM 63F95
UM 63F96
1
-UM 63F97
UM 63F98
1
-UM 63F99
(Note): The above table shows the unit memory numbers of axis number 1. For details of the whole configuration,
refer to "16.8.1 Configuration of Synchronous Control Setting Area".
16-80
Name Default Description
Cam control
synchronous
U1
master axis
cycle
Reserved for
-
system
Cam pattern
U1
number
Cam stroke
U1
amount
Advance
angle
correction K0
reference
amount
Advance
angle
correction U100
reference
speed
Set the cam control synchronous master cycle.
U1 to U2147483647
-
Set the registered cam pattern number to be used.
1 to 256
Displacement amount upper limit setting for cam
control
U1 to U2147483647
Set the correction reference amount for calculating
the advance angle correction amount when using
the advance angle correction function.
Range: -2,147,483,648 to 2,147,483,647
The ranges vary depending on the unit settings as
below.
pulse: -2,147,483,648 to 2,147,483,647 pulses
μm (0.1 μm): -214,748,364.8 to 214,748,364.7 μm
μm (1 μm): -2,147,483,648 to 2,147,483,647 μm
inch (0.00001 inch): -21,474.83648 to 21,474.83647
inches
inch (0.0001 inch): -214,748.3648 to 214,748.3647
inches
degree (0.1 degree): -214,748,364.8 to
214,748,364.7 degrees
degree (1 degree): -2,147,483,648 to 2,147,483,647
degrees
Any other settings will be errors.
Set the reference speed for calculating the advance
angle correction amount when using the advance
angle correction function.
Range: 1 to 2,147,483,647
Any other settings will be errors.
The ranges vary depending on the unit settings as
below.
pulse: 1 to 2,147,483,647 pps
μm: 1 to 2,147,483,647 μm/s
inch: 0.001 to 2,147,483.647 inch/s
degree: 0.001 to 2,147,483.647 rev/s
●: Available, -: Not available
R W
 
-
 
 
 
 
-