Snmp; The "Show" Commands - Siemens SCALANCE XM-400 Configuration Manual

Network protocols

7.7 SNMP

Requirement
● The interface is an IPv6 interface.
● The DHCPv6 relay agent is enabled.
● In "
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 dhcp relay remote-id userDefined <user-specific-ascii string(128)>
The parameter has the following meaning:
Parameter
user-specific-
ascii
Result
The designation is specified.
Further notes
You enable the remote ID with the
You enable the DHCPv6 relay agent with the
You configure the interface as a router port with the
You configure the remote ID type with the
7.7 SNMP
This section describes commands of the Simple Network Management Protocol (SNMP).
7.7.1

The "show" commands

This section describes commands with which you display various settings.
340
",
remote-id type userDefined
Description
Designation of the remote ID. max. 128 characters
is set.
Range of values / note
ipv6 dhcp relay remote-id.
ipv6 address dhcp relay
no switchport
ipv6 dhcp relay remote-id type
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.
command.
command.
command.