Set Remote-Access Ipaddress Permit/Deny - Zte ZXR10 2900E Series Command Reference Manual

ZXR10 2900E Series Command Reference
Default
Any IP address can log in to the switch.
Example
The following example enables all IP addresses to manage the switch:
zte(cfg)#set remote-access any

5.1.2 set remote-access ipaddress permit/deny

Purpose
This command sets whether the specified IP address or network segment can access the
switch through SSH/SNMP/Telnet/Web.
Command Mode
Global configuration mode
Syntax
set remote-access ipaddress <A.B.C.D>[<A.B.C.D>][{snmp | telnet | ssh | web}{permit | deny}]
Parameters
Parameter
<A.B.C.D> (first)
<A.B.C.D> (second)
snmp
telnet
ssh
web
permit
deny
Guidelines
This command without a mask indicates a host address and the 255.255.255.255 mask is
used by default. The command with a mask indicates a network segment address.
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
IP address.
Mask.
Configures whether the specified IP address or network segment
can log in to the switch through SNMP.
Configures whether the specified IP address or network segment
can access the switch through Telnet.
Configures whether the specified IP address or network segment
can access the switch through SSH.
Configures whether the specified IP address or network segment
can access the switch through WEB.
Permits access.
Denies access. The management packets are discarded.
5-2
ZTE Proprietary and Confidential