Set Qos Traffic-Limit Port Trap - Zte ZXR10 2900E Series Command Reference Manual

ZXR10 2900E Series Command Reference
Example
The following example enables rate limit protection for port 2:
zte(cfg)#set qos traffic-limit port 2 protect enable
The following example enables rate limit protection for port 2 and sets the duration when
the port is unavailable to 5 minutes:
zte(cfg)#set qos traffic-limit port 2 protect time 5

4.14.23 set qos traffic-limit port trap

Purpose
This command enables the trap function for a port. When traffic on the port exceeds the
rate limit, a trap is sent to the network management system.
Command Mode
Global configuration mode
Syntax
set qos traffic-limit port <1-28> trap {enable | disable }
Parameter Description
Parameter
<1-28>
enable
disable
Guidelines
This command is mutually exclusive with the set qos traffic-limit port protect command.
Before configuring this command, enable the traffic-limit trap function. For details, refer to
5.4.12 set trap
Example
The following example enables the trap function for port 2:
zte(cfg)#config snmp
zte(cfg-snmp)#set trap trafficlimit enable
zte(cfg-snmp)#exit
zte(cfg)#set qos traffic-limit port 2 trap enable
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
Port number. The range varies with the device type. Use the
2928E as an example.
Enables the trap function.
Disables the trap function.
enable/disable.
4-318
ZTE Proprietary and Confidential