Zte ZXR10 2900E Series Command Reference Manual page 213

Syntax
iptv channel-group mvlan <1-4094> groupiplist <A.B.C.D>{<A.B.C.D>| mask <A.B.C.D>}}[n
ame <channel-group-name>[id <0-255>]]
Parameters
Parameter
<1-4094>
<A.B.C.D>
<A.B.C.D>
mask <A.B.C.D>
name<channel-group-name>
id <0-255>
Guidelines
If the channel-group-name parameter is not selected, the channel group name and ID use
the default values. A channel group ID is calculated by the system. If the channel group
ID is 5, the corresponding channel group name is CHGNAME5. To configure the channel
group name when creating a channel group, select the channel-group-name parameter.
The channel group ID is optional but must be an unused one. The channel group name
cannot be chgnameN, where N ranges from 0 to 255.
Example
The following example creates a channel group in VALN1. The start IP address in the
group is 225.0.1.1, and the end IP address is 225.0.1.10. The channel group name is lsj
and the channel group ID is 100.
zte(cfg-nas)#iptv channel-group mvlan 1 groupip-list 225.0.1.1 225.0.1.10 name lsj id 100
zte(cfg-nas)#show iptv channel-group
MaxChannelGroupNum:256
CurChannelGroupNum:1
HisChannelGroupNum:1
Id Name
----- ----------
100 LSJ
If masks are configured, IP addresses are displayed the same way.
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
VLAN ID of the channel group.
Start group IP address.
End group IP address.
Mask.
Channel group name. The maximum channel group number is
256.
Channel group ID.
StartIp EndIp/Mask
------------- ------------- ------
225.0.1.1 225.0.1.10
4-153
Chapter 4 Service Configuration
MVlan
1
ZTE Proprietary and Confidential