Show Protocol-Protect Limit - Zte ZXR10 2900E Series Command Reference Manual

Example
The following example shows the protocol protect statistics on port 1:
zte(cfg)#show protocol-protect statistic port 1
Port 1 protocol protect alarm: Enable
ProtocolName
-------------------------------------------------------------
stp
lacp
ip

4.33.12 show protocol-protect limit

Purpose
This command shows information about the PP protocol rate limit value.
Command Mode
All configuration modes
Syntax
show protocol-protect limit
Example
The following example shows the rate limit value of the protocol packet sent to the CPU:
zte(cfg)#show protocol-protect limit
ProtocolGroup
----------------------------
ieee-reserved1
loopdetect
ieee-reserved2
igmp
vbas
arp-request
udld
route
4.33.13 show protocol-protect priority
Purpose
This command shows the configuration of packet priorities.
SJ-20130731155059-003|2013-11-27 (R1.0)
CurTotalRcvCnt Last30sRcvCnt
10809 16
0 0
12332 0
1s'limit ProtocolGroup
----------------------------
128 zesr
128 arp-reply
128 802.1x
256 dhcp
128 pppoe-plus
256 sflow
256 ipv4
64 cfm
4-511
Chapter 4 Service Configuration
30s'Limit
1200
1200
1200
1s'limit
128
256
128
512
128
768
512
128
ZTE Proprietary and Confidential