Set Qos Traffic-Limit Port Packet-Type - Zte ZXR10 2900E Series Command Reference Manual

4.14.14 set qos traffic-limit port packet-type

Purpose
This command sets the packet types to which the rate limit function is applied.
Command Mode
Global configuration mode
Syntax
set qos traffic-limit port <1-28> packet-type {broadcast | known-uc | multicast | tcp-syn | unk
nown-uc}{enable | disable}
Parameter Description
Parameter
<1-28>
broadcast
known-uc
multicast
tcp-syn
unknown-uc
enable
disable
Default
The rate limit function is enabled for the specified packet type.
Example
The following example enables rate limit for broadcast packet in the ingress direction for
port 2:
zte(cfg)#set qos traffic-limit port 2 packet-type broadcast enable
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
Number of an FE port. Different devices have different port
number ranges. In the syntax, the 2928E device is used as an
example.
Specifies whether to apply the rate limit function to broadcast
packets.
Specifies whether to apply the rate limit function to known unicast
packets.
Specifies whether to apply the rate limit function to multicast
packets.
Specifies whether to apply the rate limit function to packets
initiated by TCP links.
Specifies whether to apply the rate limit function to unknown
unicast packets.
Enables the rate limit function for the specified packet type.
Disables the rate limit function for the specified packet type.
4-311
Chapter 4 Service Configuration
ZTE Proprietary and Confidential