Set Mac To Permanent Auto-Save-Time - Zte ZXR10 2900E Series Command Reference Manual

Parameter Description
Parameter
port
<1-28>
trunk
<1-15>
enable
disable
<1-128>
Guidelines
If the function of transforming MAC addresses from dynamic to permanent in batches is
enabled, the MAC addresses that have been learned on a port/trunk will be transformed to
permanent addresses. If the maximum number of the batch-transformed MAC addresses
is exceeded, the transformation is stopped. If not, the later learned MAC addresses are
transformed to permanent addresses automatically until the maximum number is reached.
Permanent MAC addresses can be recovered after the device is restarted.

4.7.20 set mac to permanent auto-save-time

Purpose
This command sets autosave time for MAC address transformation to permanent.
Command Mode
Global configuration mode
Syntax
set mac to permanent auto-save-time <300-7200>
Parameter Description
Parameter
<300-7200>
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
Sets on a port the function of transforming MAC addresses from
dynamic to permanent in batches.
Port number. Different devices have different port number ranges.
In the syntax, the 2928E device is used as an example.
Sets on a trunk the function of transforming MAC addresses from
dynamic to permanent in batches.
Trunk ID.
Enables the function of transforming MAC addresses from
dynamic to permanent in batches.
Disables the function of transforming MAC addresses from
dynamic to permanent in batches.
Maximum number of the batch-transformed MAC addresses.
Description
Autosave time (minutes).
4-103
Chapter 4 Service Configuration
ZTE Proprietary and Confidential