Set Ipport Vlan - Zte ZXR10 2900E Series Command Reference Manual

Parameters
Parameters
<0-63>
<HH.HH.HH.HH.HH.HH>
Guidelines
MAC addresses range from 00.d0.d0.f0.00.00 to 00.d0.d0.ff.ff.ff. If the MAC address for a
layer-3 port is not configured, the MAC address of the switch is used instead. If the MAC
address for a layer-3 port is already configured, use this command to replace the original
MAC address with a new one. To modify the MAC address, disable the layer-3 port first.

4.17.6 set ipport vlan

Purpose
This command binds a layer-3 port to a VLAN.
Command Mode
Layer-3 configuration mode
Syntax
set ipport <0-63> vlan <1-4094>
Parameters
Parameter
<0-63>
<1-4094>
Guidelines
If the port to be configured is already bound to a VLAN, use this command to replace the
original VLAN with a new one. To modify the VLAN, disable the layer-3 port first.
Example
The following example configures a layer-3 port:
zte(cfg)#config router
zte(cfg-router)#set ipport 0 ipaddress 10.40.88.200/24
zte(cfg-router)#set ipport 0 vlan 1
zte(cfg-router)#set ipport 0 mac 00.d0.d0.f1.11.11
zte(cfg-router)#set ipport 0 enable
zte(cfg-router)#exit
SJ-20130731155059-003|2013-11-27 (R1.0)
Description
Number of a layer-3 port
MAC address
Description
Number of a layer-3 port
VLAN ID
4-359
Chapter 4 Service Configuration
ZTE Proprietary and Confidential