Enable Cfm Snmp Traps - Dell Force10 S4810P Configuration Manual

Enable CFM SNMP Traps.

Task
Enable SNMP trap messages for
Ethernet CFM.
A Trap is sent only when one of the five highest priority defects occur, as shown in
SNMP Traps," in
Table 5-2. ECFM SNMP Traps
Cross-connect defect
Error-CCM defect
MAC Status defect
Remote CCM defect
RDI defect
Three values are giving within the trap messages: MD Index, MA Index, and MPID. You can reference
these values against the output of
.
mep
FTOS#show ethernet cfm maintenance-points local mep
-------------------------------------------------------------------------------
MPID
-------------------------------------------------------------------------------
100
FTOS(conf-if-gi-0/6)#do show ethernet cfm domain
Domain Name: My_Name
MD
Level: 0
Total Service: 1
MA-Index
Domain Name: Your_Name
MD Index: 2
Level: 2
Total Service: 1
MA-Index
84
| 802.1ag
Command Syntax
snmp-server enable traps ecfm
802.1ag.
%ECFM-5-ECFM_XCON_ALARM: Cross connect fault detected by MEP 1 in Domain customer1 at Level 7 VLAN 1000
%ECFM-5-ECFM_ERROR_ALARM: Error CCM Defect detected by MEP 1 in Domain customer1 at Level 7 VLAN 1000
%ECFM-5-ECFM_MAC_STATUS_ALARM: MAC Status Defect detected by MEP 1 in Domain provider at Level 4 VLAN 3000
%ECFM-5-ECFM_REMOTE_ALARM: Remote CCM Defect detected by MEP 3 in Domain customer1 at Level 7 VLAN 1000
%ECFM-5-ECFM_RDI_ALARM: RDI Defect detected by MEP 3 in Domain customer1 at Level 7 VLAN 1000
show ethernet cfm domain
Domain Name
MA Name
cfm0
test0
Index: 1
Services
MA-Name
1 test
Services
MA-Name
1 test
and
show ethernet cfm maintenance-points local
Level Type Port
VLAN Dir
7 MEP Gi 4/10
10 DOWN 00:01:e8:59:23:45
VLAN CC-Int
0 1s
VLAN CC-Int
100 1s
Command Mode
CONFIGURATION
Table 5-2, "ECFM
CCM-Status
MAC
Enabled
X-CHK Status
enabled
X-CHK Status
enabled