Snmp-Server Enable Traps - Dell Networking 7048 Reference Manual

Example
The following example displays setting up the system contact point as
"Dell_Technical_Support".
console(config)# snmp-server contact Dell_Technical_Support

snmp-server enable traps

Use the snmp-server enable traps command in Global Configuration mode to
enable sending SNMP traps globally or to enable sending individual SNMP
traps. Use the no form of this command to disable sending SNMP traps
individually or globally.
Syntax
snmp-server enable traps [acl | all | auto-copy-sw | captive-portal
dot1q | dvrmp | link | maclock | multiple-users | ospf
ospfv3type
|pim |poe | snmp authentication | spanning-tree | stack |vrrp]
no snmp-server enable traps [acl | all|auto-copy-sw | captive-portal
| dot1q | dvrmp | link | maclock| multiple-users | ospf
ospfv3type
| pim | poe | snmp authentication | spanning-tree |stack|vrrp ]
• cp-type - { all, client-auth-failure, client-connect, client-db-full,
client-disconnect }
• ospftype - { all | errors { all | authentication failure | bad packet |
config error | virt authentication failure | virt bad packet | virt config
error } | lsa { all | lsa-maxage | lsa-originate } | overflow { all | lsdb-
overflow | lsdbapproaching- overflow } | retransmit {all | packets |
virt-packets } | state-change { all | if state change | neighbor state
change | virtifstate change | virtneighbor state change }}
• ospfv3type - {all | errors { all | bad packet | config error | virt bad
packet | virt config error } | lsa { all | lsa-maxage | lsa-originate } |
overflow { all | lsdb-overflow | lsdb-approaching-overflow } |
retransmit {all | packets | virt-packets } | state-change { all | if state
change | neighbor state change | virtif state change | virtneighbor
state change }}
1590
SNMP Commands
cp-type
ospftype
| ospfv3
cp-type
ospftype
| ospfv3
|