4.2 Print Info
Prints out the detailed printer settings and configuration information.
4.2.1 Executing Print Info
1)
Turn off the power.
2)
Turn on the power while holding down "
3)
Release the fingers from these keys when "Diagnosing..." is displayed.
4)
The "Customer Mode" and "IOT Diag" are displayed. (Entered the Diag. mode.)
5)
Press "
" to select "Print Info", and then press "
6)
Press "
" and "
7)
Press "
" key twice to execute the setting.
- To exit the test or to return to one step higher menu, press the "CANCEL" key.
- A test is not performed when an obstacle is in IOT.
4.2.2 Config Page
The version of software of IOT and the printer configuration can be confirmed by executing this
test.
4.2.3 Print Settings
The service tag, printing count value and error count value can be confirmed by executing this test.
4.3 Complete
Completes the diagnosis operation and reboot the data.
4.3.1 Executing Complete
1)
Turn off the power.
2)
Turn on the power while holding down "
3)
Release the fingers from these keys when "Diagnosing..." is displayed.
4)
The "Customer Mode" and "IOT Diag" are displayed. (Entered the Diag. mode.)
5)
Press "
" to select "Complete", and then press "
6)
Press "
" key twice to execute the setting.
To exit the test or to return to one step higher menu, press the "CANCEL" key.
4.3.2 Complete
Completes the diagnosis operation and reboot the data.
" key to select the item.
2 - 33
" and "
" keys.
" key.
" and "
" keys.
" key.
Chapter 2 Operation of Diag.