Fip-1. 49 Paper Jam 077-102 - Dell 2130cn Service Manual

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

FIP-1. 49 Paper Jam 077-102

Step
Possible causative parts:
CASSETTE ASSY 250 (PL2.1.1)
SEPARATOR ROLLER ASSEMBLY (PL2.1.5)
CLUTCH ASSY DRV (PL3.1.1)
SOLENOID FEED (PL3.1.11)
HARN ASSY L SIDE (PL3.1.18)
ROLL ASSY FEED (PL3.2.4)
ACTUATOR REGI ROLL (PL3.2.8)
ACTUATOR REGI IN (PL3.2.11)
SENSOR PHOTO (PL3.2.13)
DRIVE ASSY MAIN (PL7.1.2)
DRIVE ASSY PH (PL7.1.4)
PWBA MCU (PL8.2.13)
HARN ASSY MAIN MOT (PL9.1.7)
HARN ASSY KSNR REGCL (PL9.1.9)
Checking the paper condition
1
Is the paper in the Tray 1 wrinkled or damaged?
2
Does the error still occur when printing?
Checking after reloading a new paper
3
Reload a new paper in the Tray 1.
Does the error still occur when printing?
Checking the COVER ASSY FRONT for latching
Open and close the COVER ASSY FRONT, and then latch
4
correctly.
Does the error still occur when printing?
Checking the Main Motor (DRIVE ASSY MAIN) for
operation
Does the Main Motor (DRIVE ASSY MAIN) operate
properly?
5
Checked by [Digital Output]-[DO-0] on [IOT Diag] of
diagnosis.
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK).
Checking the DRIVE ASSY PH for operation
Does the ROLL ASSY FEED, ROLL ASSY REGI and ROLL
REGI METAL rotate properly?
6
Checked by [Digital Output]-[DO-B] on [IOT Diag] of
diagnosis.
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK).
Checking the paper feeding position
7
Is the paper not fed from the Tray 1?
Checking after resetting the Guide Sides and End Guide on
the Tray 1
8
Reset the Guide Sides and End Guide, and reseat the Tray
1 to the printer correctly.
Does the error still occur when printing?
Check
1 - 248
Chapter 1 Troubleshooting
Remedy
Yes
Replace the paper
with a new and dry
Go to step 3.
one, then go to
step 2.
Go to step 3.
End of work.
Go to step 4.
End of work.
Go to step 5.
End of work.
Go to step 6.
Go to step 18.
Reseat or replace
the DRIVE ASSY
Go to step 7.
PH. (Refer to
Removal 31/
Replacement 23.)
Go to step 8.
Go to step 12.
Go to step 9.
End of work.
No

Advertisement

Table of Contents
loading

Table of Contents