Fip-1. 40 Load Ssf 024-969 / Pause Feed Ssf 024-985 / Check Ssf 075-923 - Dell 2130cn Service Manual

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

FIP-1. 40 Load SSF 024-969 / Pause Feed SSF 024-985 / Check SSF 075-923

Step
Possible causative parts:
HARN ASSY L SIDE (PL3.1.18)
SENSOR PHOTO (PL3.2.13)
ACTUATOR SSI (PL3.2.14)
PWBA MCU (PL8.2.13)
Checking the paper for loading and setting
Check that the loaded paper meets the print job.
Check that the paper setting to require the print job meets
1
the specification.
Does the error still occur after reloading the paper and
chaging the paper settings that requires the print job?
Checking after setting the guide sides of the SSF
2
Reset the guide sides.
Does the error still occur when printing?
Checking after reloading a paper to SSF
3
Reload a correct paper to fill the paper setup.
Does the error still occur when printing?
Checking the ACTUATOR SSI for shape and operation
Remove the CHUTE LOW (PL3.2.27) once to check the
4
shape and operation.
Are the shape and operation of the ACTUATOR SSI
normal?
Checking the SSF No Paper Sensor (SENSOR PHOTO) for
operation
Remove the CHUTE LOW (PL3.2.27) once to check the
operation.
5
Does the number on the screen increase by one, when the
actuator (ACTUATOR SSI) of the SSF No Paper Sensor
(SENSOR PHOTO) is operated?
Checked by [Digital Input] - [DI-0] in [IOT Diag] of diagnosis.
Checking the connectors of the SENSOR PHOTO (SSF No
Paper Sensor) for connection
Check the connections between the PWBA MCU and
SENSOR PHOTO.
Are P/J23 and P/J233 connected correcly?
6
7
Does the error still occur when printing?
Checking the HARN ASSY L SIDE for continuity
Disconnect J23 from the PWBA MCU.
8
Disconnect J233 from the SENSOR PHOTO.
Is each cable of J23 <=> J233 continuous?
Check
1 - 223
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2.
End of work.
Go to step 3.
End of work.
Go to step 4.
End of work.
Reseat the
ACTUATOR SSI.
If broken or
Go to step 5.
deformed, replace
the ACTUATOR
SSI.
Replace the
PWBA MCU.
(Refer to Removal
Go to step 6.
43/ Replacement
11.)
Reconnect the
connector(s) P/
Go to step 8.
J23 and/or P/J233
correctly, then go
to step 7.
Go to step 8.
End of work.
Replace the
Go to step 9.
HARN ASSY L
SIDE.
No

Advertisement

Table of Contents
loading

Table of Contents