Dell 2130cn Service Manual page 527

Chapter 3 Removal and Replacement Procedures (RRPs)
Removal 35 KIT FEED ROLL/SOL/CLUTCH (PL3.1.99)
1) Remove the Tray 1. (Removal 1)
2) Open the COVER ASSY FRONT (PL1.2.1).
Note: Cover the drum of the PHD unit to avoid exposure to light.
3) Remove the PHD Unit. (Removal 4)
Note: The FUSER part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the KIT FUSER ASSY. (Removal 5)
5) Remove the COVER ASSY TOP. (Removal 10)
6) Remove the COVER ASSY WINDOW TNR. (Removal 8)
7) Remove the COVER SIDE R. (Removal 13)
8) Remove the COVER SIDE L. (Removal 17)
9) Remove the COVER REAR. (Removal 29)
10) Remove the CLUTCH ASSY DRV and BEARING REGI. (Removal 30)
11) Remove the KIT DRIVE ASSY PH. (Removal 31)
12) Release the hook of the ROLL CORE
MSI (PL3.2.3) on the left of the ROLL
ASSY FEED (PL 3.2.4), and move the
ROLL CORE MSI to left until it stops.
13) Release the groove on the ROLL
ASSY FEED from the vertical pin mounted
on the SHAFT ASSY FEED (PL3.2.2) by
sliding the ROLL ASSY FEED to the left.
14) Close the COVER ASSY FRONT.
3 - 76