Dell 2130cn Service Manual page 637

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

Chapter 3 Removal and Replacement Procedures (RRPs)
7) Fit the ROLL ASSY FEED to the SHAFT
ASSY FEED with the groove of the ROLL
ASSY FEED facing upward, rotate the
ROLL ASSY FEED 180 degrees so that
the pin on the SHAFT ASSY FEED is
aligned with the groove on the ROLL ASSY
FEED.
8) Open the COVER ASSY FRONT.
9) Move the ROLL ASSY FEED to the right
side, put the groove of the ROLL ASSY
FEED on the pin of the SHAFT ASSY
FEED.
3 - 186

Advertisement

Table of Contents
loading

Table of Contents