Chapter 3 Removal and Replacement Procedures (RRPs)
Note: When carrying out the work described below, leave the relay connector on the COVER
ASSY FRONT side.
10) Release the harness of the HARNESS
ASSY PNL A (PL1.1.20) from the rib of the
printer, disengage the connector (P/J2900)
of the HARNESS ASSY B (PL9.1.12).
11) Release the HARN ASSY DUP RELAY
and the HARNESS ASSY PNL A from the
hooks of the printer.
12) Remove the one screw (silver, 6mm)
that fixes the grounding terminal of the
HARN ASSY GND (PL1.2.22), release the
HARN ASSY GND from the GUIDE
HARNESS AC (PL8.2.6) and the hooks of
Note: Described below is the removal procedure common among the left and right COVER LINK
3 - 49