Fip-1. 43 Paper Jam 072-100 / Paper Jam 072-908 - Dell 2130cn Service Manual

FIP-1. 43 Paper Jam 072-100 / Paper Jam 072-908

Step
Possible causative parts:
PWBA MCU (PL8.2.13)
HARN ASSY TEAY MOT (PL12.2.2)
CLUTCH ASSY DRV (PL12.2.6)
MOTOR ASSY SUB (PL12.2.16)
ROLL ASSY FFED (PL12.4.4)
SENSOR PHOTO (12.4.13)
CASSETTE ASSY 250 OPT (PL12.5.1)
HOLDER ASSY SEPARATOR (12.5.5)
Checking the paper condition
1
Is the paper in the Tray 2 wrinkled or damaged?
2 Does the error still occur when printing?
Checking after reloading a new paper
3 Reload a new paper in the Tray 2.
Does the error still occur when printing?
Checking the COVER ASSY FRONT for latching
Open and close the COVER ASSY FRONT, and then latch
4
correctly.
Does the error still occur when printing?
Checking the Paper Path Sensor (SENSOR PHOTO) for
operation
5 Does the number on the screen increase by one, when the
actuator (ACTUATOR REGI IN) is operated?
Checked by [Digital Input] - [DI-A] in [IOT Diag] of diagnosis.
Checking the MOTOR ASSY SUB for operation
Does the MOTOR ASSY SUB operate properly?
Checked by [Digital Output]-[DO-17] on [IOT Diag] of
6
diagnosis.
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK).
Checking the paper feeding
7
Is the paper fed from the Tray 2?
Checking after resetting the Guide Sides and End Guide on
the Tray 2
8 Reset the Guide Sides and End Guide, and reseat the Tray2
to the printer correctly.
Does the error still occur when printing?
Checking the HOLDER ASSY SEPARATOR on the Tray 2
for shape and rotation
9 Pull the Tray 1 out from the printer.
Is the HOLDER ASSY SEPARATOR not contaminated and/
or damaged, and rotated smoothly?
Checking the ROLL ASSY FEED for shape and rotation
Pull the Tray 1 out from the printer.
10
Is the ROLL ASSY FEED not contaminated and/or
damaged, and rotated smoothly?
Check
1 - 231
Chapter 1 Troubleshooting
Remedy
Yes
Replace the paper
with a new and dry
Go to step 3.
one, then go to
step 2.
Go to step 3. End of work.
Go to step 4. End of work.
Go to step 5. End of work.
Go to step 6. Go to step 15.
Go to step 7. Go to step 19.
Go to step 12. Go to step 8.
Go to step 9. End of work.
Replace the
HOLDER ASSY
SEPARATOR.
Go to step 10.
(Refer to Removal
39/ Replacement
15.)
Replace the ROLL
ASSY FEED.
Go to step 11. (Refer to Removal
9/ Replacement
45.)
No