Dell 2130cn Service Manual page 531

Chapter 3 Removal and Replacement Procedures (RRPs)
Removal 36 BREAKER GFI (PL8.2.11)
1) Remove the Tray 1. (Removal 1)
2) Open the COVER ASSY FRONT (PL1.2.1).
Note: Cover the drum of the PHD unit to avoid exposure to light.
3) Remove the PHD Unit. (Removal 4)
Note: The FUSER part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the KIT FUSER ASSY. (Removal 5)
5) Remove the COVER ASSY TOP. (Removal 10)
6) Remove the COVER ASSY WINDOW TNR. (Removal 8)
7) Remove the COVER SIDE R. (Removal 13)
8) Remove the COVER SIDE L. (Removal 17)
9) Remove the COVER REAR. (Removal 29)
10) Remove the two screws (silver, tap,
8mm) that fix the BRACKET SW (PL8.2.8)
to the printer.
Note: The MAIN SWITCH and the printer are connected with the harness, so they should not be
far apart when carrying out the work described next procedure.
11) Release the BRAKET SW from the
hook together with the MAIN SW.
3 - 80