Dell 2130cn Service Manual page 644

Chapter 3 Removal and Replacement Procedures (RRPs)
3) Attach the GEAR P2 to the shaft of
DRIVE ASSY SUB.
Note: Ensure that the GEAR P2 is
oriented to the direction shown in the
right.
Note: When carrying out the work
described next procedure, ensure that
the flat face of the PIVOT TRANS L is
oriented to the direction shown in the
right.
4) Mate the tab of the STOPPER PIVOT
with the notch of the DRIVE ASSY MAIN,
attach the STOPPER PIVOT to the PIVOT
TRANS L.
3 - 193