Dell 2130cn Service Manual page 493

Hide thumbs Also See for 2130cn:

Table of Contents

Chapter 3 Removal and Replacement Procedures (RRPs)

Removal 22 SENSOR PHOTO: SSI NO PAPER (PL3.2.13)

1) Remove the Tray 1. (Removal 1)

2) Open the COVER ASSY FRONT (PL1.2.1).

Note: Cover the drum of the PHD unit to avoid exposure to light.

3) Remove the PHD Unit. (Removal 4)

Note: The FUSER part is very hot. Take added care not to get burned when performing the

service operation.

4) Remove the KIT FUSER ASSY. (Removal 5)

5) Remove the COVER ASSY TOP. (Removal 10)

6) Remove the COVER ASSY WINDOW TNR. (Removal 8)

7) Remove the COVER SIDE R. (Removal 13)

8) Remove the COVER SIDE L. (Removal 17)

9) Remove the KIT TRANSFER ASSY. (Removal 21)

Note: When carrying out the work described next procedure, take care not to move the

BRACKET SNS from the printer too far because they are connected with the harness.

10) Remove the two screws (silver, tap,

8mm) that fix the BRACKET SNS

(PL3.2.28) to the printer, remove the

BRACKET SNS.

11) Lift the rear part of the BRACKET SNS

up to release the two holes of the

BRACKET SNS from the bosses of the

Chapters

Table of Contents