Flows 85 Faint Print (Low Contrast) - Dell 2130cn Service Manual

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

Flows 85 Faint print (Low contrast)

Mnt01100KA
Checking the error mode
Does the printout light occur
when copying?
Checking the original
Is the original color density low?
END, change the original.
Faint
Mnt01101KA
No
Yes
Checking the Faint print.
Print the Windows test page.
Is the printout light (low density)?
No
Yes
Checking the printer driver settings
Select [Printer Settings] from the [General] tab
under [Properties] on the printer driver. Clear
the [Toner Saving Mode] check box under the
[Advanced] tab.
Is the printout still light (low tone)?
Checking the printer setting
Is the [Lighter/Darker] of the [Copy Default] in
the [Copy] of the [Default Settings] the default
value?
Checking the PHD ASSY sealing tape
After turning the printer off, open the front
cover and remove the PHD ASSY from the
printer.
Remove any of the 8 pieces of sealing tape
that may be left on the PHD ASSY.
Then, install the PHD ASSY into the printer.
If the tape is found, it takes a long time until
the density is recovered. To use the printer
immediately, change the PHD ASSY to
another one.
Does the error still occur after turning the
power off and on?
If the copy finish is too light, restoring the
default [Color balance Y, M, C and K] of
[Copy Defaults] in [Copy] of [Default
Settings] settings may solve it.
Yes
Yes
Yes
Yes
A
1 - 135
Chapter 1 Troubleshooting
No
Check the print data which
the problem generated.
No
END
No
Set to the default value.
No
END

Advertisement

Table of Contents
loading

Table of Contents