Dell 2130cn Service Manual page 675

Chapter 3 Removal and Replacement Procedures (RRPs)
Note: When carrying out the work
described next procedure, make sure
that the position of the GEAR T4 is
correctly.
Note: When carrying out the work described next procedure, keep the TRANSFER ASSY slightly
lifted for ease of work.
3) Attach the GEAR T4 to the printer, align
the holes of the GEAR T4, the printer
frame, and the TRANSFER ASSY, and
then insert the PIVOT TRANS L.
Note: When carrying out the work
described next procedure, ensure that
the flat face of the PIVOT TRANS L is
oriented to the direction shown in the
right.
3 - 224