1.2 General notes
The string "(PL X.Y.Z)" suffixed to the part name in the procedure denotes that the part corre-
sponds to the plate (PL) "X.Y", item "Z" of [Engineering Parts list], and its shape and fitting
position can be checked in [Engineering Parts list].
Directional descriptions used in the procedures are defined as follows:
-Front : Direction toward you when facing the front of the printer.
: Direction opposite to the front when facing the front of the printer.
: Left-hand direction when facing the front of the printer.
: Right-hand direction when facing the front of the printer.
The string "(RRP X.Y)" that appears in or at the end of the procedure denotes that the related
service procedure is described in [RRP X.Y].
Screws shown in the illustrations are to be unscrewed and removed using a Phillips head
(cross-slot) screwdriver, unless otherwise specified.
Black arrows shown in the illustrations denote moving directions. When numbers are
assigned to these arrows, they refer to the order in the procedure.
Refer to [Chapter 4 Plug/Jack (P/J) Connector Locations] for the positions of connectors (P/J).
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure: Definitions of Printer Orientation