Fip-1. 61 Ctd Sensor Dirty 092-310 / Ready To Print 092-410 - Dell 2130cn Service Manual

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

FIP-1. 61 CTD Sensor Dirty 092-310 / Ready to Print 092-410

Step
Possible causative parts:
HARN ASSY L SIDE (PL3.1.18)
TRANSFER ASSY (PL6.1.7)
PWBA MCU (PL8.2.13)
Turn OFF the power, and gently wipe the CTD (ADC)
Sensor window with a clean dry cloth or cotton swab.
After wiping the window, close the COVER ASSY FRONT.
Does the error still occur when the power is turned OFF and
ON?
1
Checking the connectors for connection
Check the connectors between the PWBA MCU and CTD
(ADC) Sensor.
Are P/J28 and P/J281connected correctly?
2
Does the error still occur when the power is turned OFF and
3
ON?
Checking the HARN ASSY L SIDE for continuity
Disconnect J28 from the PWBA MCU.
4
Disconnect J281 from the TRANSFER ASSY.
Is each cable of J28 <=> J281 continuous?
Checking the surface of the belt on the TRANSFER ASSY
5
Is the belt dirty?
Does the error still occur when the power is turned OFF and
6
ON?
Checking after replacing the TRANSFER ASSY
Replace the TRANSFER ASSY or CTD (ADC) Sensor.
7
(Refer to Removal 21/Replacement 33.)
Does the error still occur when the power is turned OFF and
ON?
Check
ADC Sensor window
Go to step 2.
Rio01012KA
Go to step 4.
Go to step 4.
Go to step 5.
Clean the belt with
a clean dry cloth,
then go to step 6.
Go to step 7.
Replace the
PWBA MCU.
(Refer to Removal
43/ Replacement
11.)
1 - 271
Chapter 1 Troubleshooting
Remedy
Yes
No
End of work.
Reconnect the
connector(s) P/
J28 and/or P/J281
correctly, then go
to step 3.
End of work.
Replace the
HARN ASSY L
SIDE.
Go to step 7.
End of work.
End of work.

Advertisement

Table of Contents
loading

Table of Contents