Dell 2130cn Service Manual page 367

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

Step
Checking the PHD ASSY for connection
Remove the PHD ASSY.
Are five HV terminals on the PHD ASSY, and five springs on
the frame (PL4.1.10 and PL4.1.15 to 18) dirty and/or
deformed?
5
Checking after reseating the PHD ASSY
6
Reseat the PHD ASSY.
Is the image printed correctly?
Checking after reseating the FUSER ASSY
Warning: Start the operation after the FUSER ASSY has
7
cooled down.
Reseat the FUSER ASSY.
Is the image printed correctly?
Checking the TONER CARTRIDGE (Y/M/C/K)
8
Are the TONER CARTRIDGEs that meet the specification
installed to the correct position?
Checking after reseating the PWBA MCU
9
Reseat the PWBA MCU.
Is the image printed correctly?
Checking after reseating the PWBA ESS
10
Reseat the PWBA ESS.
Is the image printed correctly?
Checking after reseating the TRANSFER ASSY
11
Reseat the TRANSFER ASSY.
Is the image printed correctly?
Checking after reseating the PWBA HVPS
12
Reseat the PWBA HVPS.
Is the image printed correctly?
Check
1 - 341
Chapter 1 Troubleshooting
Remedy
Yes
Clean and/or
replace the PHD
Go to step 6.
ASSY or
SPRING(s).
End of work.
Go to step 7.
End of work.
Go to step 8.
Replace a new
TONER
CARTRIDGE (Y/
M/C/K) meets the
Go to step 9.
specification.
(Refer to Removal
6/ Replacement
48.)
End of work.
Go to step 10.
End of work.
Go to step 11.
End of work.
Go to step 12.
End of work.
Go to step 13.
No

Advertisement

Table of Contents
loading

Table of Contents