Fip-Control Panel Freezes - Dell 2130cn Service Manual

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

FIP-Control Panel Freezes

Step
Possible causative parts
PWBA ESS (PL8.1.7)
Checking the operating environment.
1
Is the printer connected to the Network?
Checking the IP address.
2
Can you change the IP address?
Checking the internet connectivity.
3
Is there any internet connection available for your PC?
Updating the firmware to the latest version.
Download the latest version of the firmware from the DELL
Support Website, and execute the update.
NOTE: Before updating the firmware to the latest
version, reset the error following the steps of procedure
4
described below. In addition, update the firmware by
way of a USB storage.
1) Remove the network cable.
2) Connect the USB cable.
3) Turn the power off and on.
Does the error persist when the power is turned off and on?
Changing the IP address.
Contact your system administrator for obtaining a new IP
address.
5
Refer to Reference_1 for details of how to change the IP
address.
Does the error persist when the power is turned off and on?
Reference_1:Changing the IP address
1) Remove the network cable, and power off the printer and then on
2) Change the IP address on the Control Panel.
3) Plug the network cable back into the printer, and then turn the power on.
4) On the Control Panel, open [Admin] > [Network] > [TCP/IP], and confirm that the IP
Check
address has been changed.
Go to step 2.
Go to step 5.
Go to step 4.
Replace the
PWBA ESS.
(Removal 42/
Replacement 12)
Replace the
PWBA ESS.
(Removal 42/
Replacement 12)
1 - 378
Chapter 1 Troubleshooting
Remedy
Yes
No
Replace the
Printer.
Go to step 3.
Replace the
PWBA ESS.
(Removal 42/
Replacement 12)
End of work.
End of work.

Advertisement

Table of Contents
loading

Table of Contents