Dell 2130cn Service Manual page 374

Step
Checking the PHD ASSY for connection
Remove the PHD ASSY.
Are five HV terminals on the PHD ASSY, and five springs on
the frame (PL4.1.10 and PL4.1.15 to 18) dirty and/or
deformed?
8
Checking after reseating the PHD ASSY
9 Reseat the PHD ASSY.
Is the image printed correctly?
Checking after reseating TONER CARTRIDGEs (Y/M/C/K)
Reseat the TONER CARTRIDGEs (Y/M/C/K), and check
10
that their lock keys are in the lock positions.
Is the image printed correctly?
Checking after reseating the FUSER ASSY
Warning: Start the operation after the FUSER ASSY has
11 cooled down.
Reseat the FUSER ASSY.
Is the image printed correctly?
Checking after reseating the PWBA MCU
12 Reseat the PWBA MCU.
Is the image printed correctly?
Checking after reseating the PWBA ESS
13 Reseat the PWBA ESS.
Is the image printed correctly?
Checking after reseating the TRANSFER ASSY
14 Reseat the TRANSFER ASSY.
Is the image printed correctly?
Checking after reseating the PWBA HVPS
15 Reseat the PWBA HVPS.
Is the image printed correctly?
Check
1 - 348
Chapter 1 Troubleshooting
Remedy
Yes
Clean and/or
replace the PHD
Go to step 9.
ASSY or
SPRING(s).
End of work. Go to step 10.
End of work. Go to step 11.
End of work. Go to step 12.
End of work. Go to step 13.
End of work. Go to step 14.
End of work. Go to step 15.
End of work. Go to step 16.
No