Fip-1. 55 Paper Jam - Dell 2130cn Service Manual

Hide thumbs Also See for 2130cn:
Table of Contents

Advertisement

FIP-1. 55 Paper Jam 077-900

Step
Possible causative parts:
FUSER ASSY (PL6.1.1)
HARN ASSY FUSER2 (PL6.1.2)
PWBA MCU (PL8.2.13)
Checking the paper feeding
1
Was a paper fed from SSF?
Checking the paper setting
2
Was the paper correctly set to SSF without slant?
3
Does the error still occur when printing?
Checking the paper condition
4
Is the paper wrinkled or damaged?
5
Does the error still occur when printing?
Checking after reloading a new paper
6
Reload a new paper.
Does the error still occur when printing?
Checking the COVER ASSY FRONT for latching
Open and close the COVER ASSY FRONT, and then latch
7
correctly.
Does the error still occur when printing?
Checking the FUSER ASSY
Are there any remaining paper and/or foreign substance in
8
the FUSER ASSY?
Warning: Start the operation after the FUSER ASSY has
cooled down.
Checking after reseating the FUSER ASSY
Reseat the FUSER ASSY.
9
Warning: Start the operation after the FUSER ASSY has
cooled down.
Does the error still occur when printing?
Checking the Exit Sensor for operation
Does the number on the screen increase by one, when the
actuator of the Exit Sensor in the FUSER ASSY is
10
operated?
Checked by [Digital Input] - [DI-3] in [IOT Diag] of diagnosis.
Warning: Start the operation after the FUSER ASSY has
cooled down.
Check
1 - 260
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2.
Go to step 4.
Set the paper to
Go to step 4.
SSF correctly, and
go to step 3.
Go to step 4.
End of work.
Replace the paper
with a new and dry
Go to step 6.
one, then go to
step 5.
Go to step 7.
End of work.
Go to step 7.
End of work.
Go to step 8.
End of work.
Remove the paper
and/or substance,
Go to step 9.
then go to step 9.
Go to step 10.
End of work.
Replace the
PWBA MCU.
(Refer to Removal
Go to step 11.
43/ Replacement
11.)
No

Advertisement

Table of Contents
loading

Table of Contents