Activating An Allow/Prohibit Matrix Configuration - Brocade Communications Systems Brocade 8/12c User Manual

4. Enter a name for the configuration.
5. Enter a description for the configuration.
6. Select the check box for the device to which you want to save the configuration in the Select
7.

Activating an Allow/Prohibit Matrix configuration

NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
You must have an active zone configuration before you can activate a Allow/Prohibit Matrix
configuration.
1. Select Configure > Allow/Prohibit Matrix.
2. Select the Allow/Prohibit Matrix configuration you want to activate. You can do this by
3. Click Activate.
Brocade Network Advisor IP User Manual
53-1002168-01
FIGURE 330
Save As/Duplicate dialog box
Switch table.
Click OK.
A message displays stating that the outstanding port configuration is discarded when copying
a configuration from the switch with more ports to a switch with fewer ports and vice versa.
Click OK to close the message.
The saved configuration displays in the Available Switches table under the selected switch. To
edit this configuration, refer to
"Configuring an Allow/Prohibit Matrix manually"
The Configure Allow/Prohibit Matrix dialog box displays.
expanding the view for the switch under Available Switches and selecting a configuration, or
you may select the matrix under Allow/Prohibit Matrix.
A confirmation message displays.
Activating an Allow/Prohibit Matrix configuration
"Configuring an Allow/Prohibit Matrix"
on page 707.
23
on page 706 or
711