Configure Slb Failover Dead-Frequency - Extreme Networks ExtremeWare Command Reference Manual

configure slb failover dead-frequency

configure slb failover dead-frequency <seconds>
Description
Configures the frequency at which the local switch attempts to re-establish communication with an
unresponsive remote switch.
Syntax Description
dead-frequency
Default
The default dead frequency is 2 seconds.
Usage Guidelines
To enable active-active operation, use the following command:
enable slb failover
Example
The following command sets the dead frequency to 5 seconds:
configure slb dead-frequency 5
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all "i" series platforms.
ExtremeWare 7.7 Command Reference Guide
The frequency at which the local switch attempts to re-establish communication with an
unresponsive remote switch. The range is 1 to 60.
configure slb failover dead-frequency
511