Monitor-Link Group - 3Com 5500-EI PWR Reference Manual

undo link-aggregation group group-id
View
Monitor link group view
Parameters
group-id: Link aggregation group ID, ranging from 1 to 416 (A link aggregation group can be a manual or
static link aggregation group only).
uplink: Specifies the specified link aggregation group as the uplink port of the monitor link group
downlink: Specifies the specified link aggregation group as the downlink port of the monitor link group
Description
Use the link-aggregation group command to configure the specified link aggregation group as a
monitor link group member.
Use the undo link-aggregation group command to remove the specified link aggregation group from
the current monitor link group.
In Monitor Link, a monitor link group member can be a single port, a manual or static link aggregation
group, but not a dynamic link aggregation group. Uplink port can also be a smart link group.
Use this command only on the link aggregation groups that are not smart link group members.
A port or a link aggregation group cannot serve as a member port for two smart link groups. On the
other hand, a port or a link aggregation group cannot serve as a member of a smart link group and a
monitor link group at the same time. However, a smart link group can serve as the uplink member port
of a monitor link group.
Examples
# Configure link aggregation group 8 as the downlink port of the monitor link group.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] monitor-link group 1
[Sysname-mtlk-group1] link-aggregation group 8 downlink

monitor-link group

Syntax
monitor-link group group-id
undo monitor-link group group-id
View
System view
2-2