Test-Time Begin - 3Com 5500-EI PWR Reference Manual

Description
Use the statistics keep-time command to configure the retaining time of the test statistics.
Use the undo statistics keep-time command to remove your configuration and restore the default.
Examples
# Configure the retaining time of the test statistics to 180 minutes.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] statistics keep-time 180

test-time begin

Syntax
test-time begin { hh:mm :ss [ yyyy/mm/dd ] | now } lifetime lifetime
undo test-time
View
remote-ping test group view
Parameters
hh:mm:ss: Test start time.
yyyy/mm/dd: Test start time, yyyy is the year in the range 2000 to 2099, mm is the month in the range 1
to 12 and dd is the date in the range 1 to 31.
now: Specifies a test that starts from now.
lifetime: Lasting time of a test, in the range 1 to 2147483647 in seconds.
Description
Use the test-time begin command to configure the start time and the lasting time of a test.
Use the undo test-time command to stop the test and remove the configuration.
When the test is not performed, the configuration information you input is saved, including test start
time and lasting time.
If you set a start time earlier than the current system time or the test lasting time you configured is
0, the test will not be performed.
When a test is being performed, you cannot perform any configuration; otherwise the system
prompts error.
After you configure this command, if the test-related parameters are not complete, the system
prompts configuration error.
The test starts until you execute the test-time begin command.
If you set a start time earlier than the current system time, when you modify the current system time,
the test will not be performed.
If lifetime of the test group expires, the test will stop and when you modify the current system time,
the test will not be performed.
1-33