Schedule Reboot Delay - 3Com 5500-EI PWR Reference Manual

Examples
# Suppose the current time is 05:06, schedule a reboot so that the switch reboots at 22:00 on the
current day.
<Sysname> schedule reboot at 22:00
Reboot system at 22:00 2000/04/02(in 16 hours and 53 minutes)
confirm?[Y/N]:y
<Sysname>

schedule reboot delay

Syntax
schedule reboot delay { hh:mm | mm }
undo schedule reboot
View
User view
Parameters
hh:mm: Reboot waiting delay, where hh ranges from 0 to 720, and mm ranges from 0 to 59. The value of
hh:mm can be up to 720:00.
mm: Reboot waiting delay, ranging from 0 to 43,200 minutes.
Description
Use the schedule reboot delay command to enable the delay reboot function on the switch, and set
the reboot delay time.
Use the undo schedule reboot command to disable the delay reboot function.
By default, the delay reboot function is disabled on the switch.
Note that:
The switch timer is precise to one minute. When the reboot time reaches, the switch will reboot in
one minute at most.
You can set the reboot delay in two formats: the hour:minute format and the absolute minute format,
and both must be less than or equal to 30 × 24 × 60 (that is, 30 days).
After you execute the command, the system will prompt you to confirm. Enter "Y" or "y" for your
setting to take effect. Your setting will overwrite the previous one (if there is a setting already
exists).
If you adjust the system time by the clock command after executing the schedule reboot delay
command, the configured schedule reboot delay command will be invalid and the scheduled
reboot will not happen.
Related commands: reboot, schedule reboot at, undo schedule reboot, display schedule reboot.
Examples
# Suppose the current time is 05:15, schedule a reboot so that the switch reboots after 70 minutes.
<Sysname> schedule reboot delay 70
Reboot system at 06:25 2000/04/02(in 1 hours and 10 minutes)
confirm?[Y/N]:y
3-15