Source-Port - 3Com 5500-EI PWR Reference Manual

For FTP tests, this command is required. This command does not apply to DHCP tests. For other
tests, this command is optional.
The specified source IP address by this command cannot be of an interface on a remote device,
and the interface must be Up; otherwise the test will fail.
Examples
# Configure the source IP address as 169.254.10.2 for this ICMP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] test-type icmp
[Sysname-remote-ping-administrator-icmp] source-ip 169.254.10.2

source-port

Syntax
source-port port-number
undo source-port
View
remote-ping test group view
Parameters
port-number: Protocol source port number, in the range of 1 to 50000.
Description
Use the source-port command to configure the protocol source port number for the current test.
Use the undo source-port command to remove the configured source port number.
This command does not apply to ICMP, DHCP, and DNS tests.
Examples
# Configure the source port number as 8000 for the tcpprivate test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] remote-ping administrator tcpprivate
[Sysname-remote-ping-administrator-tcpprivate] test-type tcpprivate
1-31