Frequency; Ftp-Operation - 3Com 5500-EI PWR Reference Manual

[Sysname-remote-ping-administrator-ftp] ftp-operation put
[Sysname-remote-ping-administrator-ftp] filesize 2000

frequency

Syntax
frequency interval
undo frequency
View
remote-ping test group view
Parameters
interval: Automatic test interval in seconds. It ranges from 0 to 65,535.
Description
Use the frequency command to configure the time interval of performing automatic tests.
Use the undo frequency command to restore the default.
If interval is configured greater than 0, the system performs automatic tests at this interval.
interval defaults to 0, which means no automatic test is performed by default.
Related commands: count.
The frequency command does not apply to DHCP tests.
The frequency command supports fabric only when the test type of this test group is ICMP. With
fabric enabled, you are allowed to configure the frequency command and use the display
command to check your configuration, but unless the test type is ICMP, your configuration does not
take effect until fabric is disabled.
Examples
# Set the automatic test interval to 10 seconds in an ICMP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] test-type icmp
[Sysname-remote-ping-administrator-icmp] destination-ip 169.254.10.3
[Sysname-remote-ping-administrator-icmp] frequency 10

ftp-operation

Syntax
ftp-operation { get | put }
1-18