Priority - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

priority

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
priority
To configure the priority in a QoS policy map class, use the priority command in QoS policy class map
configuration submode. To disable this feature, use the no form of the command.
Syntax Description high
low
medium
Defaults
The default priority is low.
Command Modes
QoS policy map class configuration submode.
Command History Release
1.3(1)
Usage Guidelines Before you can configure the priority in a QoS policy map class you must first:
•
•
•
•
Examples The following example shows how to select the QoS policy class-map1 and configure the frame priority
as high.
switch(config-pmap)# class class-map1
switch(config-pmap-c)# priority high
Operation in progress. Please check class-map parameters
switch(config-pmap-c)#
Related Commands Command
qos enable
qos class-map
qos policy-map
Cisco MDS 9000 Family Command Reference
18-40
priority {high | low | medium}
no priority {high | low | medium}
Configures the frames matching the class-map as high priority.
Configures the frames matching the class-map as low priority. The default.
Configures the frames matching the class-map as medium priority.
Modification
This command was introduced.
Enable the QoS data traffic feature using the qos enable command.
Configure a QoS class map using the qos dwrr-q command.
Configure a QoS policy map using the qos policy-map command.
Configure a QoS policy map class using the class command.
Description
Enables the QoS data traffic feature on the switch.
Configures a QoS class map.
Configure a QoS policy map.
Chapter 18 P Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x