Switchport Promiscuous-Mode - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

switchport promiscuous-mode

To configure the promiscuous-mode in Gigabit Ethernet interfaces, use the switchport
promiscuous-mode command in interface configuration submode. Use the no form of the command to
delete the configured switch port information.
Syntax Description
off
on
Defaults Disabled
Command Modes Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines Access this command from the
Examples The following example enables promiscuous mode on a Gigabit Ethernet interface.
switch# config terminal
switch(config)# interface gigabitethernet 8/1
switch(config-if)# switchport promiscuous-mode on
The following example disables promiscuous mode on a Gigabit Ethernet interface.
switch(config-if)# switchport promiscuous-mode off
The following example disables promiscuous mode on a Gigabit Ethernet interface.
switch(config-if)# no switchport promiscuous-mode
Related Commands Command
show interface
gigabitethernet
OL-18089-01, Cisco MDS NX-OS Release 4.x
switchport promiscuous-mode {off | on}
no switchport promiscuous-mode
Disables promiscuous mode.
Enables promiscuous mode.
Modification
This command was introduced.
Description
Displays an interface configuration for a specified Gigabit Ethernet
interface.
submode for Gigabit Ethernet interfaces.
switch(config-if)#
Cisco MDS 9000 Family Command Reference
switchport promiscuous-mode
21-95