Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 815

Chapter 16 N Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ntp
To configure NTP settings on the switch, use the ntp command in configuration mode.
Syntax Description
peer hostname
server
tstamp-check
Defaults This command has no default settings.
Command Modes Configuration mode.
Command History Release
NX-OS 4.1(3)
1.0(2)
Usage Guidelines
None.
If the MDS does not see the server's time updates for a longer period of time, it starts polling the server,
Note
else it will not poll the server at all. Even after the poll, if the time updates are not coming, the poll
interval is reduced till it can elicit a response. The poll interval is reduced up to a minimum of 4 seconds.
Examples This example forms a server association with a server.
switch(config)# ntp server 10.10.10.10
switch(config)#
This example forms a peer association with a peer. You can specify multiple associations.
switch(config)# ntp peer 10.20.10.0
switch(config)#
Related Commands Command
ntp distribute
show ntp
OL-18089-01, Cisco MDS NX-OS Release 4.x
ntp {peer hostname | server | tstamp-check}
The hostname/IP address of the NTP peer (Max Size - 80).
The hostname/IP address of the NTP server (Max Size - 80).
Enables or disables the Timestamp Check.
Modification
Added a Note.
This command was introduced.
Description
Enables CFS distribution for NTP.
Displays NTP information.
Cisco MDS 9000 Family Command Reference
ntp
16-11