Suspend - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

suspend

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
suspend
To suspend a switched port analyzer (SPAN) session, use the suspend command in SPAN session
configuration submode. To disable the suspension, use the no form of the command.
Syntax Description This command has no arguments or keywords.
Defaults
Disabled.
Command Modes
SPAN session configuration submode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples
The following example shows how to suspend a SPAN session.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# span session 1
switch(config-span)# suspend
switch(config-span)# do show span session 1
Session 1 (admin suspended)
switch(config-span)#
The following example shows how to disable the suspension of the SPAN session.
switch(config-span)# no suspend
Cisco MDS 9000 Family Command Reference
21-78
suspend
no suspend
Modification
This command was introduced.
Destination is not configured
No session filters configured
Ingress (rx) sources are
fc3/13,
Egress (tx) sources are
fc3/13,
End with CNTL/Z.
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 21 S Commands