Policy - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 18 P Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

policy

To enter IKE policy configuration and configure a policy for the IKE protocol, use the policy command
in IKE configuration submode. To delete the policy, use the no form of the command.
Syntax Description priority
Defaults None.
Command Modes IKE configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples The following example shows how to configure a policy priority number for the IKE protocol.
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# policy 1
switch(config-ike-ipsec-policy)#
Related Commands Command
crypto ike domain ipsec
crypto ike enable
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
OL-18089-01, Cisco MDS NX-OS Release 4.x
policy priority
no policy priority
Specifies the priority for the IKE policy. The range is 1 to 255, where 1 is the
high priority and 255 is the lowest.
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Cisco MDS 9000 Family Command Reference
policy
18-13