Debug Idehsd - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 6 Debug Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

debug idehsd

To enable IDE hot swap handler debugging, use the debug idehsd command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
Syntax Description
cmd dbglevel
debug-level
error
flow
Defaults Disabled.
Command Modes EXEC mode.
Command History Release
1.0(2)
Usage Guidelines
None.
Examples
The following example displays the system output when the debug idehsd cmd dbglevel command is
issued:
switch# debug idehsd cmd dbglevel 5
set debug level to 5 succeeded
Related Commands Command
no debug all
OL-18089-01, Cisco MDS NX-OS Release 4.x
debug idehsd {cmd dbglevel [debug-level] | error | flow}
no debug idehsd {cmd dbglevel [debug-level] | error | flow}
Modification
This command was introduced.
Description
Disables all debugging.
Enables debugging for the IDE hot swap handler.
(Optional) Specifies the debug level (0 to 8).
Enables debugging for IDE hot swap handler error conditions.
Enables debugging for IDE hot swap handler flow.
Cisco MDS 9000 Family Command Reference
debug idehsd
6-59