Show Ip Traffic; Show Ips Arp - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

show ip traffic

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show ip traffic
To display IP protocol statistics for the system, use the show ip traffic command.
Syntax Description
interface
gigabitethernet slot/port
Defaults None.
Command Modes
EXEC mode.
Command History Release
3.0(1)
Usage Guidelines None.
Examples The following example displays IP protocol statistics for the Gigabit Ethernet interface.
switch# show ip traffic interface gigabitethernet 2/2
IP Statistics for GigabitEthernet2/2
Rcvd:
Sent:
Frags: 0 reassembled, 0 timeouts, 0 couldn't reassemble
ICMP Statistics:
Rcvd:
Sent:
Related Commands Command
show ip arp
show ip interface
Cisco MDS 9000 Family Command Reference
22-184
show ip traffic [interface gigabitethernet slot/port]
Modification
This command was introduced.
0 total, 0 local destination
0 errors, 0 unknown protocol, 0 dropped
30 total, 0 forwarded 0 dropped
0 fragmented, 0 fragments created, 0 couldn't fragment
0 total, 0 errors, 0 unreachables, 0 time exceeded
0 echo, 0 echo reply, 0 mask requests, 0 mask replies
0 redirects, 0 timestamp requests, 0 timestamp replies
0 total, 0 errors, 0 unreachables, 0 time exceeded
0 echo, 0 echo reply, 0 mask requests, 0 mask replies
0 redirects, 0 timestamp requests, 0 timestamp replies
Description
Displays IP neighbors for the system.
Displays IP interface status and configuration information.
Displays the IP neighbors for a specified interface.
Specifies the Gigabit Ethernet interface by slot and port number. The
range is 1 to 6.
Chapter 22 Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x