Fcsp Enable - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fcsp enable

To enable the Fibre Channel Security Protocol (FC-SP) in a switch, use the fcsp enable command in
configuration mode. Further FC-SP commands are available when the FC-SP feature is enabled. To
disable FC-SP, use the no form of the command.
Syntax Descriptionf
fcsp
enable
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
1.3(1)
NX-OS 4.1(1b)
Usage Guidelines
None.
Examples The following example enables FC-SP.
switch# config terminal
switch(config)# fcsp enable
switch(config)#
Related Commands Command
show fcsp
OL-18089-01, Cisco MDS NX-OS Release 4.x
fcsp enable
no fcsp enable
Specifies the FC-SP feature in the switch.
Enables the FC-SP feature in this switch.
Modification
This command was introduced.
This command was deprecated.
Description
Displays configured FC-SP information.
Cisco MDS 9000 Family Command Reference
fcsp enable
8-51