Show Interface Transceiver - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Chapter 22
Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show interface transceiver

To display the SFP and X2 digital monitoring information for a transceiver, use the show interface
transceiver details command.
Syntax Description
Interface fc-id
Defaults
None.
Command Modes
Exec mode
Command History
Release
3.0
Usage Guidelines
This command displays the attributes of a transceiver such as, the vendor, the kind of laser it emits and
receives, compatible fiber optic cable, distances supported, vendor's firmware revision, faults the unit
experienced since the last insertion or since the last linecard boot (whichever is the latest) and, the
diagnostics information (if supported by the unit)
Examples
The following example displays the SFP digital monitoring information for a transceiver (DOM
unsupported SFP):
switch#show interface fc4/1 transceiver details
fc4/1 sfp is present
The following example displays the X2 digital monitoring information for a transceiver.
switch# show interface fc1/1 transceiver details
fc1/1 sfp is present
OL-18089-01, Cisco MDS NX-OS Release 4.x
show interface fc-id transceiver details
Specifies the fiber channel interface ID.
Modification
This command was introduced.
name is CISCO-FINISAR
part number is FTRJ8519P1BNL-C1
revision is A
serial number is FNS0838B0CX
fc-transmitter type is short wave laser w/o OFC (SN)
fc-transmitter supports intermediate distance link length
media type is multi-mode, 62.5m (M6)
Supported speed is 200 MBytes/sec
Nominal bit rate is 2100 MBits/sec
Link length supported for 50/125mm fiber is 500 m(s)
Link length supported for 62.5/125mm fiber is 300 m(s)
cisco extended id is unknown (0x0)
no tx fault, rx loss, no sync exists, Diag mon type 136
Digital diagnostics feature not supported in SFP
name is CISCO
part number is FTLX8541E2-C1
show interface transceiver
Cisco MDS 9000 Family Command Reference
22-175

Advertisement

Table of Contents
loading

Table of Contents