Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 997

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
traffic-type
initiator
mgmt
target
tx
Defaults Disabled.
Command Modes SPAN session configuration submode.
Command History Release
1.0(2)
3.1(2)
Usage Guidelines
None.
Examples The following example shows how to create a SPAN session, then configures the SPAN traffic at all
sources in VSAN 1.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# span session 1
switch(config-span)# source vsan 1
The following example shows how to configure the SPAN source interface as PortChannel 1.
switch(config-span)# source interface port-channel 1
The following example shows how to configure the SPAN source interface as FC 9/1 with an egress filter
for VSAN 1.
switch(config-span)# source interface fc9/1 tx filter vsan 1
The following example shows how to configure the SPAN source interface as FCIP 51.
switch(config-span)# source interface fcip 51
The following example shows how to configure the SPAN source interface as iSCSI interface 4/1.
switch(config-span)# source interface iscsi 4/1
The following example shows how to disable configure the SPAN source interface as FC 9/1 with an
egress filter for VSAN 1.
switch(config-span)# no source interface fc9/1 tx filter vsan 1
OL-18089-01, Cisco MDS NX-OS Release 4.x
(Optional) Configures the SPAN traffic type.
(Optional) Specifies initiator traffic.
(Optional) Specifies management traffic.
(Optional) Specifies target traffic.
(Optional) Specifies SPAN traffic in egress direction.
Modification
This command was introduced.
Added the interface bay | ext option.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
source
21-59