Ip Default-Gateway - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

ip default-gateway

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ip default-gateway
To configure the IP address of the default gateway, use the ip default-gateway command. To disable the
IP address of the default gateway, use the no form of the command.
Syntax Description destination-ip-address
interface
cpp
slot
processor-number
vsan-id
Defaults
None.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines
None.
Examples
The following examples configures the IP default gateway to 1.1.1.4:
switch# config terminal
switch(config)# ip default-gateway 1.1.1.4
Related Commands Command
show ip route
Cisco MDS 9000 Family Command Reference
11-50
ip default-gateway destination-ip-address [interface cpp slot_number/processor-number/vsan-id]
no ip default-gateway destination-ip-address [interface cpp slot/processor-number/vsan-id]
Specifies the IP address,
Configures an interface.
Specifies a virtualization IPFC interface.
Specifies a slot number of the ASM.
Specifies the processor number for the IPFC interface. The current processor
number is always 1.
Specifies the ID of the management VSAN. The range 1 to 4093.
Modification
This command was introduced.
Description
Displays the IP address of the default gateway.
Chapter 11 I Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x