show dmm ip-peer
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show dmm ip-peer
To display information about the IP peers the DMM interface is connected to, use the show dmm ip-peer
command in EXEC mode.
Syntax Description
This command has no arguments or keywords.
Defaults
None.
Command Modes
EXEC mode.
Command History
Release
3.2(1)
Usage Guidelines
You must connect to an SSM on your switch to execute DMM show commands. Use the show module
command to determine the slot number of an SSM on your switch. Use the attach module slot command
to connect to the SSM.
Examples
The following example displays DMM IP peer information:
switch# attach module 3
Attaching to module 3 ...
To exit type 'exit', to abort type '$.'
Bad terminal type: "ansi". Will assume vt100.
module-3# show dmm ip-peer
-------------------------------------------------------------------
No
-------------------------------------------------------------------
1
2
3
Cisco MDS 9000 Family Command Reference
22-66
show dmm ip-peer
Modification
This command was introduced.
Cisco DMM IP Peer Table
Type
CONFIG_STATION
PEER_SSM
CONFIG_STATION
SD
IP Address
TCP State
23
10.100.2.1
DOWN
22
10.100.1.20
UP
19
10.100.2.1
DOWN
Chapter 22
Show Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x